Expert Answers about Palomino Sabre Fifth Wheel

• Replacement Landing Gear System for 2010 Palomino Sabre 31RETS
• Based on the weld stop measurement you listed and the GVWR of the 2010 Palomino Sabre 31RETS the Stromberg Carlson Electric Landing Gear Set # LG-3 will work really well. This system features a 6,500 pound weight capacity, provides a total lift of 34-7/8 inches, and weld stops that are spaced apart by 15-1/2 inches inside to inside (and 17-1/2 inches outside to outside) so you can use your existing brackets. A hand crank is included for manual operation if you lose power, and the direct...
  view full answer...


• Picking Out Replacement Leaf Springs for 2008 Palomino Sabre
• You do need to replace both leaf springs on either side of your axle at the same time. To pick out a replacement spring you are going to need to take a few measurements. You are going to need to measure the length of the spring without any weight on it from spring eye to spring eye, and you are going to need to know the capacity of trailer/axles so that you pick out the correct rated spring. Once you know that info you will need to check out the link I attached that has a page with all...
  view full answer...


• Will Stromberg Carlson Landing Gear LG-3 Fit RLTS Sabre by Palomino
• Yes, the Stromberg Carlson landing gear kit part # LG-3 is a fit for your 2011 Sabre by Palomino. This fits the standard landing gear applications like what your RV would have.
  view full answer...